Mains dimmable 10 meters warm white led strip kit 144W
Kit 10 meters warm white LED strip
24V SMD2835 LED chip 14.4W/m
This is a Mains Dimmable 10 meters warm white LED Strip kit (non waterproof IP00, SMD2835 LED chip)
The Kit includes all necessary products for a quick installation of up to 10 meters of single colour LED strip.
Note: wall dimmer switch is not included in the kit. It is suggested to use a dimmer capable of handling between 200 and 400W maximum. Both leading and trailing edge dimmer switches can work with this kit.
LED strip has a power consumption of max. 14.4W per meter and a brightness of about 1380lm/m. Just for reference, the light output of a 50 Watt halogen lamp is about 550lm
The following products are included to the Kit:
1 x 150W / 24V Mains Dimmable LED Driver (Triac LED dimming driver)
Model number: HL-DIM-CV-150W-24V-IP67. Also available via THIS LINK.
Can drive max of 10 meters 14.4W/m LED Strip
2 x 5 meters rolls of Warm White SMD2835 LED strip IP00 (non waterproof) 14.4W/m
Model number: HL-LS2835HB-60WW-IP00-24V. Also available via THIS LINK.
Tape comes ready with 3M double adhesive tape on the back of the flexible PCB. 15cm soldered wire tails are attached to both sides of the 5m led strip length and can be cut at every 10cm (6 LEDs). Can be installed in one run if needed (by joining the two 5 meters rolls) but the DC 24V should be fed to the LED driver from both sides of the run in parallel. Alternatively, you may power the 10m run from the middle of the 10m length.
The LED driver is IP67 and LED tape is non waterproof IP00, meaning it cannot be used in wet environments.
The Kit comes with 3 Years Guarantee.
Please make sure you know how to install the LED strip properly, avoiding voltage drop and high current through the flexible pcb of the LED strip (long runs could cause high current and damage the flexible pcb). If you are not sure about something please contact us before installing and powering the kit.