LED Driver "Premium Series" 60W 24V IP20
Premium Series LED Driver 60W
Output: 24V / 2.5A
5 years Warranty
Premium series 60W 24V LED driver - 5 years Warranty
This is a highly specified switch mode power supply using the best electronic components in the market.
Non-dimmable LED Driver suitable for LED Strips of total power consumption up to 60W.
It is recommended to calculate 20% more than the tape power consumption to cover voltage drop of the circuit.
As an example this LED Driver can be used for up to 3.50 meters of high power single colour or RGBW LED strip (14.4W per meter X 1.20 load factor).
LED Driver 60W/24V
Input: 110~220V AC (50/60Hz)
Output: 24V / 2.5 Amps
Suitable for LED Strips
Rating: IP20 (Non-Waterproof)
Dimensions: L160*W98*H35 mm
Warranty offered for the LED driver is 5 years
We also offer IP67 Premium Series 60W Driver HERE
Note that LED strips dimming is possible if this driver is used in combination with an LED controller. In such case LED driver is not required to be dimmable and brightness control (dimming) is still possible through the LED controller.
For driving RGB or RGBW LED Strips, you will have to combine the Driver with an RGB-RGBW LED Controller.
This device should be installed by a qualified electrician in accordance with the latest edition of the IEE Wiring Regulations and any applicable Building Regulations.
The table below shows the maximum LED strip length, which can be operated with this LED driver.
To consider best power supply performance 20% was deducted from the maximum strip length in the table below.
For more information about the installation of LED Strips, you can download the below PDF file: “Installation of LED Strips”.
- 24V DC
- 60 W
- IP20 (Non-waterproof)
- Voltage Type
- Constant Voltage
- 5 Years