DMX controller 4CH waterproof IP67
DMX controller 4CH waterproof IP67
DMX controller 4CH waterproof IP67
DMX controller 4CH waterproof IP67
DMX controller 4CH waterproof IP67
DMX controller 4CH waterproof IP67
DMX controller 4CH waterproof IP67
DMX controller 4CH waterproof IP67
DMX controller 4CH waterproof IP67
DMX controller 4CH waterproof IP67
DMX controller 4CH waterproof IP67
DMX controller 4CH waterproof IP67

DMX RGBW LED Waterproof Controller

  • Waterproof DMX512 4CH LED Controller
  • Constant Voltage type
  • 4 Channels DMX-512 input

Important Product Details

  • optional 250 char. max
DMX4CH-5WP
PRE-ORDER
£75.00
90.00
with VAT)
VAT excluded

The minimum purchase order quantity for the product is 5.

 

WATERPROOF DMX RGBW LED CONTROLLER (4 Channels) IP67

This is a four channel waterproof dmx512 LED controller that can drive RGB, RGBW or single colour LED strips and other constant voltage LED products.

Input voltage can vary between 12 to 36V maximum (60 to 180W respectively)

The maximum current per channel that this controller can handle is 5 Amps

DMX start address can be set at any value between 001 to 512 using the buttons available on the front panel

Start Address will be then saved in memory and even after power interruption will be recalled to the previous settings.

Installing our RGBW LED Strip (60 leds per meter) with DIN Rail DMX512 RGBW LED Controller:

RGBW LED Strip (4 in 1 integrated LED chip) has a power consumption of 14.4W per meter

That’s the power consumption of all 4 colours together, meaning an average of 3.6W per colour per meter.

Note: Those are the average readings based on 5 meters length of strip, if the length is less as an example 1 meter the power will be higher due to the reason that there is no voltage drop. (Check the RGBW Led strip page for more details).

The specific LED controller can handle a maximum of 5A per channel but is suggested to load the controller with no more than 3.5A in order to operate at lower temperatures.

Since RGBW LED strip is rated at 24 Volts, we can assume a current of 0.15A per channel (based on a average 5 meters length of rgbw led strip).

If we load the controller with the “safe” value of 3.5A per channel rated at 24V, means we can connect up to 84 Watt per channel or maximum of 23 meters of RGBW tape to every controller. Every maximum of 5 meters RGBW LED strip is suggest to be connected with the DMX LED controller directly using a separate 5 core cable. Never connect from one 5 meters roll to another unless if wired in ring configuration.

Specification

IP Rating: IP67

Input Voltage: 12 to 36 Volts DC

Output voltage: According to input voltage (12‐36V)

Maximum output current: 5 Amps per channel

Output Channels: 4 Channels

Output power: 4CH x 60‐180W each (12‐36V)

Mode: Constant Voltage

Signal input: DMX512

DMX Start Address settings: 1 to 512

Warranty: 3 Years

Brand
Hi-Line
Resolution
8-Bit
Type
RGB/RGBW controller
Voltage Type
Constant Voltage
Type of control
DMX512
Warranty
3 Years
No reviews

Customers who bought this product also bought:

Our webstore uses cookies to offer a better user experience and we recommend you to accept their use to fully enjoy your navigation.