IP65 End Cap for 10x20mm LED Neon Flex
This screw-able end cap allows you to provide a seal for one side of our Neon Flex RGBW strip to IP65.
The HL-END-P-IP68 end cap simply fits onto one end of Neon Flex, to provide a fully sealed casing.
The supplied screws secures the cap in place, for rigid protection. Included sealant can then be applied for water protection.
Fits both single and RGBW LED Neon Flex 10x20mm series
Included in the kit:
1 x End Cap
2 x Transparent grip pieces (one for each side of the flex, applied prior to sliding over the case)
1 x Rubber piece for end plate
4 x screws
Connector measures 2.6mm H x 2.5mm W x 2.9mm L
Note: Silicon Sealant is required to complete the installation and must be purchased separately from all good home depots.
- IP65 (Splashproof)
- 3 Years