HL-ED(C) is a door sensing head. It is not a mains switch, and it does not run an LED strip by itself. It needs the 5 V sensor socket on HL-E1-L, or a sensor socket on HL-ES-V. A power supply and a strip are not connected to this head.
The sensitive field is about 8 cm, over about 15 to 30 degrees. Door open, or no obstacle in that field, fades the light on. Door closed, or an obstacle in the field, fades the light off. This head does not set the brightness. For a level that a hand can change, use the hand-sweep head HL-EB(C) instead.
One controller, one head. HL-E1-L has one socket, so it takes one door head. Two doors, or a door and another head, need HL-ES-V. On HL-ES-V, leave the daylight switch and the run-on switches off. This head holds the light while the door is open. The controller must not add a daylight block or a run-on.
Where to fit it. Fit the head at the outer edge of the door, about 1 cm from the opposite face, so it sees the gap when the door opens. On a glossy face, use the sticker supplied. Concealed fitting: drill 11 mm. Surface fitting: the carabiner clip and the two screws. The round head is about 32 mm across. The clip is about 33 x 22.5 x 18 mm.
Connection. 5 V DC, from the controller socket only. The three wires are + / S / -. High is on. Low is off. The lead is about 1 m. Keep it away from mains cable. Do not power this head from the LED supply.
In the box. The head, one carabiner clip, one sticker, two screws and the user sheet. This is the larger round door head, ED(C). It is not the smaller ED-C body, and it is not the hand-sweep head. Warranty 5 years.
