HL-EB(C) is a hand-sweep sensing head. It is not a mains switch, and it does not run an LED strip by itself. It needs the 5 V sensor socket on HL-E1-L, or a sensor socket on HL-ES-V.
The sensitive field is about 10 cm, over about 15 to 30 degrees. A sweep of the hand fades the light on. A second sweep fades it off. A hold of more than 2 seconds raises or lowers the brightness, and the next hold reverses the direction. There is no separate push switch for this. The door head HL-ED(C) does not change the level. This head does.
One controller, one head. HL-E1-L takes one head. A second head needs HL-ES-V. On HL-ES-V, leave the daylight switch and the run-on switches off. This head holds the light itself.
Where to fit it. Fit it where a hand can pass the face, within about 10 cm. Concealed fitting: drill 11 mm. Surface fitting: the carabiner clip and the two screws. The round head is about 32 mm across. The clip is about 33 x 22.5 x 18 mm. The face has two windows. That is how it is told apart from the door head, which has a slot.
Connection. 5 V DC, from the controller socket only. The three wires are + / S / -. High is on. Low is off. The lead is about 1 m. Keep it away from mains cable.
In the box. The head, one carabiner clip, one sticker, two screws and the user sheet. This is the larger round hand-sweep head, EB(C). It is not the smaller EB-C body. Warranty 5 years.
