Non-dimmable LED Driver suitable for LED Strips of total power consumption up to 300W.
Please Note: It is not required to run all three white cables to your controllers, but you can do so if you wish. These additional cables are used when you are intending to install more than one run from the same driver. If you do decide to only use one of the cables then it's important to tidy up the remaining, sealing them if possible, so that the remaining red and black wires are not touching each other. This can lead to the driver shorting out if ignored.
It is recommended to calculate 20% more than the tape power consumption to cover voltage drop of the circuit.
LED Driver 300W/24V Suitable for LED Strips
Input: 170~264V AC (50/60Hz)
Output: 24V / 12.5 Amps
Rating: IP67 (Waterproof)
Dimensions: 210*125*60 mm
Weight: 2.4Kg
Warranty offered for the LED driver is 2 years
Please check out our 300W/24V premium LEd driver here
Note that LED strips dimming is possible if this driver is used in combination with an LED controller. In such case LED driver is not required to be dimmable and brightness control (dimming) is still possible through the LED controller.
For driving RGB or RGBW LED Strips, you will have to combine the Driver with an RGB-RGBW LED Controller.
IMPORTANT NOTICE!
This device should be installed by a qualified electrician in accordance with the latest edition of the IEE Wiring Regulations and any applicable Building Regulations.
The table below shows the maximum LED strip length, which can be operated with this LED driver.
To consider best power supply performance 20% was deducted from the maximum strip length in the table below.
For more information about the installation of LED Strips, you can download the PDF file in the attachments tab: “Installation of LED Strips”.
