24V Cut Anywhere Free-Cut COB LED Strip 4000K - 528 LEDs/m - 10m Reel
The 24V Cut Anywhere Free-Cut COB LED Strip 4000K is a high-density professional lighting solution featuring 528 LEDs per metre. Thanks to advanced Chip-on-Board technology, it produces a completely seamless, dot-free continuous light line that can be cut at any point along the reel.
Key Specifications: Colour Temperature: 4000K Neutral White (natural daylight white) LED Density: 528 LEDs per metre. Power: 11.5 W per metre. Voltage: 24V DC Constant Voltage Strip Width: 8mm Colour Rendering Index: CRI ≥ 90 Reel Length: 10 metres Flexible PCB with high-quality 3M self-adhesive backing
Wattage. 11.5 W per metre is the most this strip can draw. We measure a short length at a full 24 V, before any voltage drop, and that is the figure for the driver and the cable. At 24 V it is 0.48 A per metre. A full reel, power from one end only, or cable that is too thin will draw less than 11.5 W per metre, and the far end will be dimmer. It will not draw more than this. Watts are not a brightness ranking between different strips: a high-efficiency strip can give more light from fewer watts. This COB is a standard-efficiency strip, so against another standard COB of the same type the higher wattage is the brighter one.
A full reel of this strip measures below 11.5 W per metre. The figure on the listing is the short-length maximum. How we state watts per metre.
This cut-anywhere COB strip offers maximum flexibility for installers and DIY enthusiasts. The neutral 4000K light is bright yet comfortable, making it ideal for kitchens, under-cabinet lighting, offices, retail displays, furniture integration, and architectural features.
Note: In the Related Products tab below you can also find the same type of strip in a 5m reel if needed and other matching accessories.
Matching 8 mm connectors (2-pin, single colour)
This strip is 8 mm wide and 2-wire / single colour. Use only the 8 mm COB connectors in the Related Products tab — not 10 mm or RGB parts.
- Strip to power: join the strip to a cable. Pre-wired 15 cm tail HL-COB8-SP-IP00, screw-to-wire HL-SMDCOBT2-SW-8MM, or universal kit HL-COB-CON-UNI-8 (also useful for mid-run power injection).
- Strip to strip (straight): join two cut ends. Seamless joint HL-COB8-SS-IP00, or screw join HL-COBSMD-A8-IP00.
- Strip to strip with a short cable: 150 mm bridge HL-COB8-SSW-IP00.
- Corners: L-shape clip HL-COB8-L2-IP00, or L/T screw block HL-LT2-COB8-IP00.
These connectors are indoor (IP00/IP20), same as this IP20 strip. Open Related Products to add them to the basket.
