Key Features:
This is a highly specified switch mode power supply using the best electronic components in the market.
Non-Dimmable LED Driver suitable for LED Strips of total power consumption up to 100W.
It is recommended to calculate 20% more than the tape power consumption.
LED Driver 100W/24V
Input: 175~264V AC (50/60Hz)
Output: 24V / 4.16 Amps
Suitable for LED Strips
Rating: IP67 (Waterproof)
Power factor: >0.95
Efficiency: >90%
Ripple: <2%
Dimensions: L180*W60*H18.5 mm
Weight: 450g
SELV, CE & RoHS certified
Warranty offered for premium series of LED drivers is 5 Years
Note that LED strips dimming is possible if this driver is used in combination with an LED controller. In such case LED driver is not required to be dimmable and brightness control (dimming) is still possible through the LED controller.
For driving RGB or RGBW LED Strips, you will have to combine the Driver with an RGB-RGBW LED Controller.
IMPORTANT NOTICE!
This device should be installed by a qualified electrician in accordance with the latest edition of the IEE Wiring Regulations and any applicable Building Regulations.
The table below shows the maximum LED strip length, which can be operated with this LED driver.
To consider the best performance for the power supply, 20% was deducted from the maximum strip length in the table below.
For more information about the installation of LED Strips, you can download the PDF file from the attachments tab called: Installation of LED Strips.
