- New
22 mm Pixel RGB LED Neon Flex | 12V | WS2811 | 10 m
- 22 mm braided round RGB pixel tube, 10 metres, 12 V, WS2811
- 3-pin JST SM connector
- Same tube as the 3 m roll: 32 pixels per metre, three LEDs form one pixel
- Double-sided board inside the tube, 192 LEDs per metre
- 320 pixels and 1,920 LEDs on this roll. Cut only on the marked pixel point
- About 40–45 W per metre. This roll is about 400–450 W
- £500 before VAT, the same £50 per metre as the 3 m roll
HL-RGB-D22-PIX-10M is a 10 metre RGB pixel tube, 22 mm round, with a braided 360° sleeve. It runs on 12 V and uses WS2811. The lead is a 3-pin JST SM connector. It is the same tube as the 3 m roll.
The braid takes the scuffs of handling, uncoiling and fitting, so the wear is on the sleeve rather than the tube. The tube still bends, and the light is thrown all the way round.
Pixels
- 32 pixels per metre
- Three LEDs form one pixel
- The board inside the tube is double-sided, with LEDs on both faces
- 192 LEDs per metre
- 320 pixels and 1,920 LEDs on this 10 m roll
- Cut only on the marked pixel point
- Each pixel is addressed on its own
Power
About 40–45 W per metre with red, green and blue on together. That is a design figure for a suitable 12 V supply, with no voltage drop along the run. This 10 m roll is about 400–450 W. The 12 V driver has to be rated for that full figure. The largest waterproof 12 V driver on the shop is 400 W, which covers the lower end of the figure and not a 45 W per metre load, so it is not listed as a matching supply for this roll.
The 3 m roll is HL-RGB-D22-PIX-3M at £150 before VAT. The 5 m roll is HL-RGB-D22-PIX-5M at £250 before VAT. This 10 m roll is £500 before VAT, the same £50 per metre.
Products that go with this roll are listed below.
- Colour
- RGB
- LEDs per meter
- 192
- LED Chip
- IC: WS2811 (Addressable)
- LED Neon Flex Type
- Circular (dia: 22mm)
Pixel Digitally Addressable - Voltage
- 12V DC
- Warranty
- 5 Years
- Neon Flex Length (m)
- 10 metres