- New
22 mm Pixel RGB LED Neon Flex | 12V | WS2811 | 3 m
- 22 mm braided round RGB pixel tube, 3 metres, 12 V, WS2811
- 3-pin JST SM connector
- 32 pixels per metre. Three LEDs form one pixel
- Double-sided board inside the tube, 192 LEDs per metre
- 96 pixels and 576 LEDs on this roll. Cut only on the marked pixel point
- About 40–45 W per metre with red, green and blue on. Allow about 135 W for this roll
HL-RGB-D22-PIX-3M is a 3 metre RGB pixel tube, 22 mm round, with a braided 360° sleeve. It runs on 12 V and uses WS2811. The lead is a 3-pin JST SM connector.
The braid takes the scuffs of handling, uncoiling and fitting, so the wear is on the sleeve rather than the tube. The tube still bends, and the light is thrown all the way round.
Pixels
- 32 pixels per metre
- Three LEDs form one pixel
- The board inside the tube is double-sided, with LEDs on both faces
- 192 LEDs per metre
- 96 pixels and 576 LEDs on this 3 m roll
- Cut only on the marked pixel point
- Each pixel is addressed on its own
Power
About 40–45 W per metre with red, green and blue on together. That is a design figure for a suitable 12 V supply, with no voltage drop along the run. This 3 m roll is about 120–135 W at that figure. A 200 W 12 V constant-voltage driver is the practical size for the roll. Indoor and waterproof drivers are listed below, with SPI controllers, including an IP65 waterproof DMX-to-SPI decoder.
The RGBW version of this 22 mm braided 3 m tube, with 50 pixels per metre, is HL-RGBW-D22-PIX-3M.
The same tube is also sold as a 5 m roll, HL-RGB-D22-PIX-5M, at £250 before VAT, and a 10 m roll, HL-RGB-D22-PIX-10M, at £500 before VAT. Both follow this 3 m roll at £50 per metre.
Products that go with this roll are listed below.
- Colour
- RGB
- LEDs per meter
- 192
- LED Chip
- IC: WS2811 (Addressable)
- LED Neon Flex Type
- Circular (dia: 22mm)
Pixel Digitally Addressable - Voltage
- 12V DC
- Warranty
- 5 Years
- Neon Flex Length (m)
- 3 metres