- New
22 mm Pixel RGB LED Neon Flex | 12V | WS2811 | 5 m
- 22 mm braided round RGB pixel tube, 5 metres, 12 V, WS2811
- 3-pin JST SM connector
- Same tube as the 3 m roll: 32 pixels per metre, three LEDs form one pixel
- Double-sided board inside the tube, 192 LEDs per metre
- 160 pixels and 960 LEDs on this roll. Cut only on the marked pixel point
- About 40–45 W per metre. This roll is about 200–225 W
- £250 before VAT, the same £50 per metre as the 3 m roll
HL-RGB-D22-PIX-5M is a 5 metre RGB pixel tube, 22 mm round, with a braided 360° sleeve. It runs on 12 V and uses WS2811. The lead is a 3-pin JST SM connector. It is the same tube as the 3 m roll.
The braid takes the scuffs of handling, uncoiling and fitting, so the wear is on the sleeve rather than the tube. The tube still bends, and the light is thrown all the way round.
Pixels
- 32 pixels per metre
- Three LEDs form one pixel
- The board inside the tube is double-sided, with LEDs on both faces
- 192 LEDs per metre
- 160 pixels and 960 LEDs on this 5 m roll
- Cut only on the marked pixel point
- Each pixel is addressed on its own
Power
About 40–45 W per metre with red, green and blue on together. That is a design figure for a suitable 12 V supply, with no voltage drop along the run. This 5 m roll is about 200–225 W. A 300 W waterproof 12 V driver covers that load. The 400 W waterproof driver leaves more headroom. Both are listed below.
The 3 m roll is HL-RGB-D22-PIX-3M at £150 before VAT. The 10 m roll is HL-RGB-D22-PIX-10M at £500 before VAT. This 5 m roll is £250 before VAT, the same £50 per metre.
Products that go with this roll are listed below.
- Colour
- RGB
- LEDs per meter
- 192
- LED Chip
- IC: WS2811 (Addressable)
- LED Neon Flex Type
- Circular (dia: 22mm)
Pixel Digitally Addressable - Voltage
- 12V DC
- Warranty
- 5 Years
- Neon Flex Length (m)
- 5 metres