No 3M tape. This silicone sleeve is supplied without double-sided adhesive. A bare reel is not a missing part. Installers often want 3M because it is quick to fit. On this cover, acrylic tape sticks to the wall and lets go of the silicone, which is why the reel is supplied this way. If a red liner is still on the reel, peel it off. It is not the mount, and glue on that liner does not fix it. Mount the sleeve with DOWSIL 7091, white, 310 ml. The 45 g tube HL-706TM only seals a cut end and its cap. The steps, and when a clip should carry the run, are in how to mount an IP67 or IP68 silicone sleeve.
IP67 Natural White LED Strip 24V, powered by 60 SMD3528 LED chips per meter, 4.8W/m, CRI80, 5m roll, supplied without 3M tape
Commercial High Grade white LED Strip 4000K
4.8 w/m – 24V DC – 5m roll – 60 LEDs/m – IP67 (Waterproof) – 2-wire cable (15cm on each side of the strip roll)
Great for cove lighting or any application that does not require high brightness.
The high quality of Hi-Line LED strips ensures low decay, which increases the LED strip's lifespan and assures that a high level of the brightness is kept constant throughout the LED strip's life.
Please do NOT connect more than 10 meters of LED tape in series. An LED strip of more than 10 meters in length will overload, due to the increased amount of current passing through, resulting in the damage of the PCB and the failure of the LED strip. Thus, when 10 meters of LED strip is exceeded, it is suggested to connect both ends of the strip directly to the LED controller or driver using 2-core cable.
The LED strip comes with a 15cm wire ending on each side of the strip roll. Therefore, no extra soldering is required if the roll should be cut into 2 different pieces (i.e. 3 meters + 2 meters).
Please note that soldering is recommended for the connection of LED strips; solder-free connectors are not available for IP67 rated LED strips.
All Hi-Line LED strips are dimmable. Please select a suitable PWM LED dimmer/controller to ensure the proper dimming of the LED strip.
The strip can be cut every 6 LEDs (10cm). The width of the LED strip is 10mm.
Supplied without 3M tape.
Looking for Related Products or Accessories?
Click the 'Related Products' tab below the product description to find compatible LED strips, drivers, and accessories. For technical data or installation guides, check out the 'Attachment' tab for available PDFs. To refine your search further, use our "REFINE BY" filter system available when browsing any product category.
