IP67 Warm White LED Strip 24V, powered by 60 SMD3528 LED chips per meter, 4.8W/m, CRI80, 5m roll, with 3M red 4100 core series tape on the back
Commercial High Grade white LED Strip 2700K
4.8 w/m – 24V DC – 5m roll – 60 LEDs/m – IP67 (Waterproof) – 2-wire cable (15cm on each side of the strip roll)
Great for cove lighting or any application that does not require high brightness.
The high quality of Hi-Line LED strips ensures low decay, which increases the LED strip's lifespan and assures that a high level of the brightness is kept constant throughout the LED strip's life.
Please do NOT connect more than 10 meters of LED tape in series. An LED strip of more than 10 meters in length will overload, due to the increased amount of current passing through, resulting in the damage of the PCB and the failure of the LED strip. Thus, when 10 meters of LED strip is exceeded, it is suggested to connect both ends of the strip directly to the LED controller or driver using 2-core cable.
The LED strip comes with a 15cm wire ending on each side of the strip roll. Therefore, no extra soldering is required if the roll should be cut into 2 different pieces (i.e. 3 meters + 2 meters).
Please note that soldering is recommended for the connection of LED strips; solder-free connectors are not available for IP67 rated LED strips. If preferred IP00 connectors can be used after removing LED strip sleeve (FCP width for the strip is 8mm) but you must maintain IP rating for any connectors used (suggested is to use liquid electrical tape).
All Hi-Line LED strips are dimmable. Please select a suitable PWM LED dimmer/controller to ensure the proper dimming of the LED strip.
The strip can be cut every 6 LEDs (10cm). The width of the LED strip is 10mm.
Fitted with an easy to install 3M red 4100 core series tape (excellent adhesion).
