No 3M tape. This silicone sleeve is supplied without double-sided adhesive. A bare reel is not a missing part. Installers often want 3M because it is quick to fit. On this cover, acrylic tape sticks to the wall and lets go of the silicone, which is why the reel is supplied this way. If a red liner is still on the reel, peel it off. It is not the mount, and glue on that liner does not fix it. Mount the sleeve with DOWSIL 7091, white, 310 ml. The 45 g tube HL-706TM only seals a cut end and its cap. The steps, and when a clip should carry the run, are in how to mount an IP67 or IP68 silicone sleeve.
The watts per metre on this page are the total for every channel together. The common positive, usually the black wire, carries that whole current. Each colour return carries only its own share. Connector length, and the cross-section of any long feed, are set by the common wire. The calculation for RGB, RGBW, tunable white and RGB+CCT is in our guide to common anode current on colour-changing LED strip.
The silicone jacket hides the cut marks. Hold the strip to a good light and cut only on the copper pads. The spacing on this reel, and what a cut between the pads does, is in our guide to cutting an IP68 LED strip.
High bright Dynamic white LED tape designed to high specifications for professional installations
IP68 waterproof high density tunable white LED strip powered by SMD3014 LED chips
Adjustable colour temperature via tunable white from 2700 to 6500K
Note: While any type of LED strip will perform better when installed in a profile or on an aluminium flat bar, due to the nature of high-powered SMD2835 chips running warm at 19.2 watts per metre and above, we strongly suggest that you consider installing this LED strip on an aluminium bar at the very minimum, in order to ensure proper cooling and thus increasing its lifespan.
CRI Ra >80 LED chips, 240 LEDs per meter 24V 28.8W/m (120 warm + 120 cool white per meter) IP68
All Hi-Line's IP68 strips can be used in steam rooms and saunas (LED drivers and controllers should be installed remotely).
The LED chip without the IP68 coating can operate at temperatures between -25 to 60 degrees Celsius. Using Hi-Line's special coating which also acts as a coolant for the LED chips can make the final end product to stand temperatures of up to 110 Celsius. For Sauna and steam room applications it is suggested to install IP68 LED strips on aluminium flat bar, LED profile or directly on concrete walls for additional cooling, this will prolong LED chip operating time and lumen-maintenance. Please note that warranty offered for IP68 LED tape installed in Saunas, steam rooms or underwater is limited to one year.
Luminous flux: Up to 2760 lm/w (warm and cool white LED chips together)
Luminous flux for warm white LED chip: 11 lumens each
Luminous flux for cool white LED chip: 12 lumens each
Brown = +24V, Yellow = Warm White, Blue = Cool White
5m roll (10mm wide FPC - 12mm Total with IP68 coating)
Pre-soldered round flexible tails 15cm (both ends of the 5m roll)
Cuttable every 6 LEDs (50mm)
Supplied without 3M tape. See the note at the top of this page.
Applications: Cove lighting, office lighting, shop lighting
3 Years Warranty
Please click the Related Products tab to find all matching accessories for this product, including suitable connectors and more.
